I forgot, and need to buy a socket. What size is that?
99riocobra said:i want to say 32mm, but someone else might want to verify.
99cobrablack said:You doing gears or half-shafts?
BreBar21 said:It's 36mm.
BreBar21 said:It's 36mm.
BreBar21 said:Also, if you're pulling the pumpkin, why not just leave the halfshaft attached to the knuckle?? Disconnect the knuckle from the UCA, LCA, and tierod and remove it as one piece.
yea no kidding! i figured he was replacing the halfshafts or something. i did what you described above for pulling my pumpkin for gears. thanks for the correction on the size by the way.BreBar21 said:Also, if you're pulling the pumpkin, why not just leave the halfshaft attached to the knuckle?? Disconnect the knuckle from the UCA, LCA, and tierod and remove it as one piece.
That is what I was going to suggest if I would have got here in time. Don't need any special pullers, or have to retorque the hell out of that nut. Took me more time to jack my car up than it did to pull the pumpkin doing it this way.BreBar21 said:Also, if you're pulling the pumpkin, why not just leave the halfshaft attached to the knuckle?? Disconnect the knuckle from the UCA, LCA, and tierod and remove it as one piece.