Want to make my own RAI, what tubing/rubber elbows etc do I need?

[xXSVTmonsterXx]

Looking to make my own RAI... my engine is in excess of 360ci and I am looking for the best solution possible. I want something much larger than what JLT, etc will offer.

I am looking at pieces on intakehoses.com

Does any one know what rubber coupler I would need for the throttle body to 4"+ tubing?

Any recommendations for size? :beer:

 

[na svt]

The 90hl4sr will fit on the TB very tight and work with a 4" thin wall aluminum tube well.
The 90L45 fit the TB better and work with a 4" PCV tube.

 

[cobra916]

stock arm is best... nm just reread that ur going to be 360+ ci

 

[xXSVTmonsterXx]

The 90hl4sr will fit on the TB very tight and work with a 4" thin wall aluminum tube well.
The 90L45 fit the TB better and work with a 4" PCV tube.

Got it! I have a bbk for a Cobra now and was thinking I'd be too small? I want to do it right once.



Sent from my SPH-L710 using Tapatalk 2

 

[olgreydog7]

Care to translate? My JLT elbow that I use with my Sullivan rubs the 00R hood and it drives me crazy. I'm about to get a cowl hood, but if that doesn't work, I want to make something better.

 

[na svt]

Care to translate? My JLT elbow that I use with my Sullivan rubs the 00R hood and it drives me crazy. I'm about to get a cowl hood, but if that doesn't work, I want to make something better.

Where the hell have you been?

 

[olgreydog7]

You know I can't tell you exactly where. Just away for a while.