Alright so my build is coming to a close on putting parts together, im aiming for the 2nd week going into March for my initial build and put together. I'm putting the last finishing parts together but want a last final opinions on what people would suggest doing differently unless i'll be fine doing it the way im going with the build.
I still need to get my 42lb injectors, gauges + pod(s) and a tial bov 3psi spring. Any advice on this build/setup you would do differently before I get started id greatly appreciate. Also pulley size should i go from a 3.60 to a 3.33? I'm aiming for 8-10psi for boost.
Vortech parts I have put together:
Vortech V1 S-Trim - Practically Brand new
Anderson Power Pipe
Tial BOV
CX Racing Intercooler Kit 3'' Piping
SVT Fuel Pump
SCT XCAL2
Vortech Bracket Assembly, Oil Feed and Drain Lines
SCT BA2400 MAF - Going blow through. Selling this an now going with an HPX 05
Current mods on the GT:
FRPP 3.73s
Flowmaster 40 Exhaust
Mac O/R Prochamber
Stock Headers
Stock Clutch / Tranni
Stock Internals and Block
I still need to get my 42lb injectors, gauges + pod(s) and a tial bov 3psi spring. Any advice on this build/setup you would do differently before I get started id greatly appreciate. Also pulley size should i go from a 3.60 to a 3.33? I'm aiming for 8-10psi for boost.
Vortech parts I have put together:
Vortech V1 S-Trim - Practically Brand new
Anderson Power Pipe
Tial BOV
CX Racing Intercooler Kit 3'' Piping
SVT Fuel Pump
SCT XCAL2
Vortech Bracket Assembly, Oil Feed and Drain Lines
SCT BA2400 MAF - Going blow through. Selling this an now going with an HPX 05
Current mods on the GT:
FRPP 3.73s
Flowmaster 40 Exhaust
Mac O/R Prochamber
Stock Headers
Stock Clutch / Tranni
Stock Internals and Block
Last edited: