trim ring kit around Gauges in cluster
- Thread starter Epwillis
- Start date
This kit is a nice touch to a boring looking cluster, i painted mine silver to match my autometer rings.A pain to put in but worth it i think.
damn that looks good i might have to pick up a set. Where did you guys order them and how hard was the install?
American Muscle and patience!
Nice and I have none so I'll skip it. ;-)
Its not that bad, the rings just snap in. I say maybe 30-40 min tops start to finish.
I have a set too and they look great. The only problem I had was the boost gauge ring was a tad tight and I had to trim the needle a little. I kept getting stuck at around 2 pounds of boost. I tried to move the lens cover as it moves a little but it didn't work.
Last edited:
1sickcobra
Banned
I did a carbon fiber panel on mine, but after seeing these trim rings I might make a change!
The carbon fiber with the chrome rings would look awesome
I did a carbon fiber panel on mine, but after seeing these trim rings I might make a change!
What was the trick to removing the clear cover from the gauge cluster to install the CF piece?
I don't have a picture at the moment but I have a billet machined piece around mine. It isn't separate rings like those chrome ones, but I really like the look. I believe it was made by UPR.
a sharp utility knife and a steady hand.
I did a carbon fiber panel on mine, but after seeing these trim rings I might make a change!
Where did you get that? WANT""":rockon:
I thank you. Order in
Users who are viewing this thread
