Alright so whats up guys, I have a 03 with a 3.0 pulley and simple bolt ons. The throwout started making noise and then as i would drive i would go 1-2-3-4-5-6 and it had a little like howling noise that slowly turned into grinding inbetween each gear.
Last night we replace the throw out bearing (steeda quad and FWA) with my spec 2+. First off the pedal feel is so much NICER, but it drove 5miles PERFECT then the noise/grind came back. Like when it is in neutral i push in the clutch and go to rev it it makes the grinding noise again and when I shift inbetween gears.
If i drive normally and like seriously push the clutch in in between shifts and let the r's drop it doesnt do it.
Seriously this is driving me nuts, especially pulling that damn bitch bolt at 1:00 on the tranny out.
Any ideas?
Last night we replace the throw out bearing (steeda quad and FWA) with my spec 2+. First off the pedal feel is so much NICER, but it drove 5miles PERFECT then the noise/grind came back. Like when it is in neutral i push in the clutch and go to rev it it makes the grinding noise again and when I shift inbetween gears.
If i drive normally and like seriously push the clutch in in between shifts and let the r's drop it doesnt do it.
Seriously this is driving me nuts, especially pulling that damn bitch bolt at 1:00 on the tranny out.
Any ideas?