Stock longblock/MT82 with a Procharger - 10.15 at 138.54mph

[slow306stang]

Just got home from the track a few hours ago and couldn't be any more satisfied with how today went. I've had my fair share of bad track outings with this car and today was a nice turn around.

On my first pass I took it too easy and bogged it down with a 1.72 60ft and it resulted in a 10.6 at 138.3mph. The 2nd pass I raised the launch rpm up to 5000rpm and slipped the clutch which resulted in a spinning 1.49 60ft and 10.15 at 138.5mph. Without having a roll bar my racing was done for the day. Either way I am stoked with the 10.15 pass and i'm glad it held together :-D

Setup

Wastegated D1sc on 11.6psi
E85/c85 mix and meth injection
MT82 with RXT clutch
3.31 gears
full exhaust
BOSS manifold
28x10.5 Stiff sidewall ET drag
BMR/Steeda full suspension
Est. race weight 3600-3650 lbs
Made 702whp and 657wtq on 10.1psi - Est 730whp 657wtq today with the added 1.5psi
Lund tune

There is a lot more to the car but that gives you a basic run down of what's done. Feel free to ask any questions about the car.

[video=youtube;uOaCBO2IWsQ]https://www.youtube.com/watch?v=uOaCBO2IWsQ[/video]

 

[oldbones]

Great time and MPH!!

 

[04snakie]

Congrats!! Badass for sure. I was wondering to myself the other day about mt82 and procharger/Paxton's close to the low 10's high 9's. Do you think you have a nine in her?

 

[Scott8583]

Congrats! :rockon:

That's huge mph for a stock motor! Great ET for the mt82 for sure!

 

[gimmie11s]

Hat is off to you sir. I know how hard it is to shift your way to a 10 sec pass (and you are knocking on 9s door!). Well done! Car is building great power.

Any in-car vid?

 

[slow306stang]

Great time and MPH!!

Thanks!!!

Congrats!! Badass for sure. I was wondering to myself the other day about mt82 and procharger/Paxton's close to the low 10's high 9's. Do you think you have a nine in her?

It spun for 10-15ft on that pass. Assuming a dead hook with no bog id think 10.0s with a low 1.4 60ft wouldn't be far fetched. It went a 1.48 60ft before but was 200 lbs heavier and made 100 less whp. If the planets aligned, dead hook, and better DA 9's could be possible.

Congrats! :rockon:

That's huge mph for a stock motor! Great ET for the mt82 for sure!

Thanks man. Every time you post it makes me want to do the 6r80 swap LOL

Hat is off to you sir. I know how hard it is to shift your way to a 10 sec pass (and you are knocking on 9s door!). Well done! Car is building great power.

Any in-car vid?

Thank you! No in car videos today as my buddy was holding the Gopro this time. I have a few in car videos my youtube page but nothing great.

 

[CM5878]

Bananas

 

[scott_0]

damn! nice run! stock MT82?

 

[CM5878]

Awesome! Now I have something new to watch on your Youtube channel.

 

[slow306stang]

damn! nice run! stock MT82?

Stock mt82 with a barton shifter, rxt, lightened steel flywheel, and clutch line

Awesome! Now I have something new to watch on your Youtube channel.

Thank you sir!

 

[SMOKIN 02]

Congrats!!! Great run. Looks like Cecil county drags thats a great track…

 

[CM5878]

How the heck have you not grenaded the trans?

 

[slow306stang]

How the heck have you not grenaded the trans?

im not quite sure. Before the clutch install it would scratch going into 2nd and 4th. Also, it would lock me out of 2nd if shifted above 6800rpm. Now with the clutch and WOT box it's butter lol

 

[slow306stang]

Installing an engine diaper and heading back to the track on Nov 14th. Wish me luck!

 

[MRSUPRA]

Great times!. MT-82 + good clutch seems to work.

 

[pierce88]

Nice!!! I will be back to Cecil on the 14th as well! Shooting for an 11 second pass with only an X-Pipe and Lund tune with my MT-82.

-Pierce

 

[Turd Fergusen]

Nice time and killer mph. I'll be there on the 14th also.

 

[99.9%stock]

Strong car and good driving!!!

 

[corepwn]

Very nice, congrats!

 

[Justin81]

Count me in for the 14th. I've been fighting the same trans problem you mentioned (locked out of 2nd) and now the new RXT feels like butter. I'm not leaving without 10 second slip.