Steeda X2's solution to prevent further dropping?

[fordfx584]

Hey guys I used the search function but couldn't find my exact answer. I'm currently running H&R SS springs with no isolators up front on my 03. I need to replace the Ball joints up front because they're shot. I've read that the x2's can drop the ride up to 1/2in up front. I do not want the car up front any lower because its where I want it. My question is could I just put isolators back up front on top? or bottom? or both to make up for the predicted drop to keep it roughly the same? Can I use the provided spacer with the kit with no isolators?What is your opinion on the best way to adjust for the predicted drop and keep my current ride height? Thanks guys for your thoughts!

 

[fordfx584]

I think I'll just utilize front polyurethane isolators for top and bottom to make up for steeda ball joint drop without using their spacers.

 

[UncleSAm]

i run just the spacer and dont have any issues, didnt change my height

 

[fordfx584]

@unclesam I wasn't sure If I could run it without an isolater though? But I guess I can?!

 

[UncleSAm]

@unclesam I wasn't sure If I could run it without an isolater though? But I guess I can?!

Yeah, I don't have isolaters. If it did change its minimal

 

[spray'n mach 1]

mine dropped about an additional 1/4 inch, I only have one iso in and decided to leave it as is.

 

[99cobrajn]

they come with spacers if you get them new then you get no drop if you run them.

 

[03' White Snake]

they come with spacers if you get them new then you get no drop if you run them.

This ^^. The spacer goes on the top of the spring fyi.

 

[fordfx584]

Thanks guys!