I wonder if they'd be willing to give up or loan out the fixtures so some small shop could make them.
Any pictures of the racecraft k member? Been looking to maybe replace my stock one while I have the suspension out. Would like a little more structure than a standard drag design but also don't feel the MM piece is needed for me.It sucks that we couldn't get this off the ground for one more run. We had a decent amount of interest previously but I did have a few people change their mind as were got closer. That, plus cost increases and the pandemic did us no favors.
For anyone still wanting a K-Member but not enthusiastic with current market choices, look into a Racecraft Mild Steel K-Member with the Road Race option. It's still the the same thin-like tubular design as every other K-Member on the market, however it has 4 lbs of additional cross bracing above the control arm mounts. It's not a whole lot by any means but I would be comfortable using it on a street car. Plus Racecraft products are good quality and are some of the best fitting. I've had the Steeda K-Member and Racecraft K-Member (standard version) both in my possession and the quality is excellent on both. I hope this at least provides a viable alternative to the Steeda.