This is just a small chunk of the car I am working on. I hope to have the whole thing done for a car show on Sat. I tested the PC out on my truck and it did pretty damn good job. My Viper isn't too bad, big spider webs but then I get some haze (didn't happen on my truck). It's basically gone when I use a glaze and then wax. You will see in the pics. vvvv
After a good wash and clay.
After PoorBoys SSR2.5 on PC spd 5.
Notice how hazy/marred it is? Did I take too long or something? Should I get lower SSR?
End Result
After Red Moose Machine Glaze and Vanilla Moose Hand Glaze then Nattys Red Paste Wax. I applied all by hand... except the Machine glaze, I don't think it works that well... the Vanilla Moose looked bit better.
Anyone use these products that can help me get best results? Any recomendations?
After a good wash and clay.
After PoorBoys SSR2.5 on PC spd 5.
Notice how hazy/marred it is? Did I take too long or something? Should I get lower SSR?
End Result
After Red Moose Machine Glaze and Vanilla Moose Hand Glaze then Nattys Red Paste Wax. I applied all by hand... except the Machine glaze, I don't think it works that well... the Vanilla Moose looked bit better.
Anyone use these products that can help me get best results? Any recomendations?