running rough

Bryan99hoss

New Member
Established Member
Joined
Sep 14, 2008
Messages
321
Location
alabama
I have a 96 cobra with a good bit of work i just traded for, I stepped in it a little hard and it shut off... I assumed that it just flooded it out, got it back and let it sit 30 hours or so and just went to crank it, and it sounds like its only running on one side....

any ideas?

I am about 2 hours from home so, any ideas would help...
 

Cookieman00x

Drunk Again.
Established Member
Joined
Apr 14, 2005
Messages
9,069
Location
S.E Pa
Can you be more spacfic to the problem.. " stepped in it a little hard and it shut off" IM not sure what you mean..
 

Bryan99hoss

New Member
Established Member
Joined
Sep 14, 2008
Messages
321
Location
alabama
it boosted and died... acts like its flooded... let it sit over night and now it sounds like its running on one side
 

Cookieman00x

Drunk Again.
Established Member
Joined
Apr 14, 2005
Messages
9,069
Location
S.E Pa
it boosted? do you have a blower on the car?

Are all your vaccum lines on the car... Check your maf to make sure there isnt a leak or the pipe came off ( if it does have a blower)
 

Bryan99hoss

New Member
Established Member
Joined
Sep 14, 2008
Messages
321
Location
alabama
oh sorry I forgot how little i wrote... yeah it has a vortec

mod list
Motor:

- Forged Steel Cobra Crank
- Manly H Beam Rods
- Manly Forged Pistons
- All ARP Bolts/Hardware
- Sean Hyland Cams
- Vortech S-trim Kit
- 42lb injectors motorsport

Parts/Mods:

- SCT programmer with Custom Tune
- 80MM SCT MAF
- Adjustable fuel reg.
- T-REX Fuel Pump
- New Motorcraft coil packs (both)
- New TPS sensor
- New Motorcraft IAC motor
- Steeda Tri-ax shifter
- Caster / Camber plates
- Jamex lowering springs (2 inch)
- Bilstien 12-way adjustable shocks and struts
- Cross drilled rotors front and rear
- Completely rebuilt and beefed up rear end with 3.73 gears and extra diff clutches
- Tubular upper and lower control arms
- Full exhaust (h-pipe) with long tubes(bbk)
- Tremec TKO-600 5 speed transmission
- Ram Clutch
 
Last edited:

Cookieman00x

Drunk Again.
Established Member
Joined
Apr 14, 2005
Messages
9,069
Location
S.E Pa
hella cammed... it does have sean hyland cams...


ummm.... do you hear any knocking, pinging slapping... anything unusual..


Who tuned the car?
 

Cookieman00x

Drunk Again.
Established Member
Joined
Apr 14, 2005
Messages
9,069
Location
S.E Pa
:smmon:

I dont know... With out any details as to what its exaclty doing... It could be anything... Id start by checking your maf.. make sure its connected and there arent any leaks, then check your coil packs and spark plug wires..


whats your fuel pressure?

What RPM did you notice there was a problem?
 

Bryan99hoss

New Member
Established Member
Joined
Sep 14, 2008
Messages
321
Location
alabama
I believe it is at 40psi, that is what it was after i shut the car off, gauge is under hood

and i was probley in the 5K range
 

Cookieman00x

Drunk Again.
Established Member
Joined
Apr 14, 2005
Messages
9,069
Location
S.E Pa
the fuel pressure should be more around 31psi at idle..

Whats the car ideling at rpm wise?

did you just feel a sudden drop in power?
 

Bryan99hoss

New Member
Established Member
Joined
Sep 14, 2008
Messages
321
Location
alabama
well, it puffs out black smoke so i assumed it was fuel...

but since it happened it hasnt moved... I just turned it over to see if it would run today, and it sounded like it had a hell of a cam,
 

Cookieman00x

Drunk Again.
Established Member
Joined
Apr 14, 2005
Messages
9,069
Location
S.E Pa
alot of smoke? a little? at startup? while ideling? only at a certain RPM?

try and be more descriptive..
 

Users who are viewing this thread



Top