Just bought a set of gen 2 6266 for my CG fab twin kit. Now I'm wondering if I should of gone bigger like a 6766. Goal is 1200+. It's Mainly a street car and I do half mile roll racing. Stick shift too.
Thanks!
Thanks!
What is the engine combo?
How high are you spinning the engine?
You will most likely need more RPM for that type of power. The 67s may be too much @ only 7,000 RPMs. Depends on some other things like cams/phasing etc.
Tony (Blk_03) runs the 6466s on a standard stroke 4.6, turbos 8,000 RPMs and traps in the 170s
Lots of people make this mistake, they want a street car to be a race car but what ends up happening is, it's not good at either. Your going to need to spin that motor pretty hard to make that, and when this happens parts break, I hope your budget allows for lots of breakage, it seems when you get over the 1000+ mark, there's a ton more maintenance and money required.