Power steering lines
- Thread starter cyclegrip
- Start date
Awesome! Can't wait to see pics!
Bumping this to see if anyone finished theirs yet? Any photos?
I did, I'll grab some pictures by the weekend
Any more pictures?
Sorry for the delay, I finally got my car running again. I built a little panel to cover some of the hydroboost stuff.
Modified Moroso tank to fit in fender well.
Russel lines and hose ends.
Modified fitting for P/S pump. I didn't use the o-ring I used an aluminum drain plug washer and red loctite.
Barb on pump feed cut off and -10 welded on.
All the fittings I used. The fittings with the white Teflon rings are from Maximum Motorsports, they are for the rack. The included washers were much nicer than the washers I found at the auto parts store.
Used an aluminum drain plug washer here too, plus red loctite. I didn't want my stuff leaking.
Made a panel for this side too.
Covered all my hoses in DEI Fire Sleeve (thanks Franz!). For these particular hoses I used the Velcro stuff so I could put it over all 3 hoses easily. Every where else I used the sleeve style DEI Fire Sleeve that slips over the hose.
It really cleaned up my engine bay!
That looks so good! I need to do this too, I hate the stock lines and their routing. I follow you on Instagram, your work is incredible!
Thanks man!
Last edited:
You sure? I can answer any questions you may have man?
Super old post, but wanted to confirm that the p/s fitting does leak without a o-ring fitting. I am going through this right now and had to remove the fitting because it was leaking just sitting there. I will now have to put o-rings on the fitting or order a better suited one...
Just installed the factory style - 2 pressure hoses. Gates brand from RockAuto. About $300 including tax and shipping.
Users who are viewing this thread
