Post UPR quadrant and Firewall adjuster install

[SLOWNED]

Hey guys, I just wanted to check if any of you who have had a UPR firewall adjuster experienced the cable not sitting flush with the adjuster knob. I made sure i followed the instructions perfectly and the cable still doesn't flush. The car shifts fine and everything but it just doesn't look right and Im not sure if i should be concerned.

Here is a pic so you can get an idea of what i mean.

 

[TRBO VNM]

Did you search? Someone just posted about this about 2-3 weeks ago and there were solutions in the thread. There is nothing wrong aside from visual if that is a problem for you.

Basically you need a rubber sleeve or tubing to go over the end of the clutch cable.

 

[10sec89]

You just need to take up the size difference from the outside of the clutch cable liner and the inside diameter of the adjuster. I wrapped my clutch cable tightly with electrical tape and have never had an issue. Not saying that's the proper way , but has worked well for me.