For the last few months we've been hearing rumblings from a few companies trying to get some cams produced for the new 5.0. I figured here would be a good place to speculate how much more power you think cams will bring to the table in these cars.
For the last few months we've been hearing rumblings from a few companies trying to get some cams produced for the new 5.0. I figured here would be a good place to speculate how much more power you think cams will bring to the table in these cars.
From what I have read and been told. Aftermarket cams will not produce any increase that you can't get from stock.
:read:
93PONY said:Full off-road exhaust done correctly (actually difficult with the mufflers at the rear of the car.....although I think simply installing cut-outs at the right place would work excellent).
C&L intake is okay, I believe the JLT is a better design for flow, and the WMS will be tops (no bends at all) in the real world, and match the JLT on the dyno.
Intake manifold porting.....if needed, I really want to yank one off and see how it all lines up with the heads. Porting plastic is tricky, but normally worth a few HP. Boss intake is also coming soon.
L&M is working on a Throttle Body. Guaranteed to be super high quality, the owner used to work in a wind tunnel for Boeing.
Meziere is supposed to be working on an electric water pump, that's an easy 15HP gain at 6500RPM on traditional modulars, more at higher RPM.
E85 will also be key as you can run 29+ degrees of ignition timing (vs 21ish on 91) and the fuel is worth 5% more power.
With all that + custom tune we're looking at 480-490ish RW. 500 is either more tuning away (if these mods need more TiVCT tuning) or one other power mod away.
Add an aluminum driveshaft, bigs & littles, gears, and I really don't see how an 10 second weekend warrior N/A isn't possible on a STOCK LONG BLOCK!
And yes, we do EVERYTHING. From chassis/suspension, to tuning, to installs, to fuel systems, to engine building and Full Race cars. AED has you covered.