Only Crushers Make Power

[Daywalker]

While this seems to be the general consensus, I think my little standard inlet did ok.

706/635
Whipple Gen IV standard inlet
3.25" upper pulley (20PSI)
Magnaflow O/R X-pipe
Magnaflow exhaust
19 degrees of timing
E85

 

[cobracide]

Did you print it on a zebra?

 

[UnrealSVT]

Your standard inlet did just fine. That photo though...feel like I dropped acid looking at it. Lol

Sent from my SM-G975U using Tapatalk

 

[Daywalker]

Did you print it on a zebra?

Only way it would post, had to resize it down to %20 of the original and this is what happened...

 

[01yellercobra]

Let's see if this works.

 

[UnrealSVT]

Let's see if this works. View attachment 1729571

Waaaaaaay better!!!

Sent from my SM-G975U using Tapatalk

 

[cobracide]

try saving it as a png then check the size. the jpeg compression is probably freaking out on the resize.

 

[CobraBob]

Great numbers with your setup. Post a couple of photos of your Cobra, including the engine bay.

 

[Daywalker]

Great numbers with your setup. Post a couple of photos of your Cobra, including the engine bay.

Thanks! Here ya go