Ok guys, if you go back just a couple of posts you can see the parts list that I have acquired and going to install this winter. What else would you guys do since the suspension is already apart? I have been reading and seen not to do poly in the rear upper control arms, but what about everywhere else? Replace factory rubber with poly, or get new arms with poly already in them? Just trying to get info from those of you who have been there before. Thanks guys.
Howdy fellers, been a long time, but I am still around. I just got around to putting on my MM caster camber plates, H&R Race springs, and some Koni Yellows. Oh and some aluminum steering rack bushings. Any who, looking for some suggestions as far as alignment goes and what to set the Koni's on for VIR if anyone has any experience there. 97 Cobra.