Attempting to do some datalogging for BJ and I'm having some trouble with it. I recently upgraded from an Xcal2 (!) and Livelink 6.5 to an X4 and Livelink Gen 2. BJ has asked that I log certain PID's, but Gen 2 doesn't have any of the following PID's - all of which show up in Livelink 6.5. I've asked Gen 2 to look for and verify all PID's, and all the vehicle info is correct. Have any of you successfully logged any of these PID's in Gen 2, and if so, could you point me to where in the list they are? I've been over it dozens of times and I'm stuck. This is for a 2007.
1) There is no PID for "returnless fuel pump duty cycle". The closest one I found is "Fuel pump duty cycle" and off to the side it says "duty cycle for modulated fuel pump";
2) There is no "injector duty cycle" anywhere.
3) There is no "MAF voltage" - only MAF in grams/second and MAF counts;
4) There is no "returnless fuel pump pressure" - only "fuel rail pressure" in PSI
Of course, the "tech rep" at SCT was both clueless and rude as hell.
1) There is no PID for "returnless fuel pump duty cycle". The closest one I found is "Fuel pump duty cycle" and off to the side it says "duty cycle for modulated fuel pump";
2) There is no "injector duty cycle" anywhere.
3) There is no "MAF voltage" - only MAF in grams/second and MAF counts;
4) There is no "returnless fuel pump pressure" - only "fuel rail pressure" in PSI
Of course, the "tech rep" at SCT was both clueless and rude as hell.
Last edited: