I am installing my stop-tech st40 brakes on my 98 cobra. I installed the stainless lines into the back of the caliper no problem. However, the other end of the line that goes into hardline on the car has a small amount of fluid coming from the threads when I connect the two. I took the line off several times and kept trying to make that connection but no matter what I do there is a small amount of brake fluid that appears from the threads of the connection.
I am 100% sure I did not cross thread anything as I am threading the fittings with my finger and then tightening with a flare wrench.
also this leak is happening with pressure static. I’m not even pushing on the brakes and have not bled them as well.
Any idea of what I need to do?
I am 100% sure I did not cross thread anything as I am threading the fittings with my finger and then tightening with a flare wrench.
also this leak is happening with pressure static. I’m not even pushing on the brakes and have not bled them as well.
Any idea of what I need to do?
Last edited: