My quickest 1/4 so far..

[Unrealford]

This Friday I went to track and ran my quickest time.

12.15 @111 in 1/4

7.68 @ 89 mph in 1/8

60 ft= 1.62

My Boss is stock except MT Drag Radial 275sx15 and Steeda UCA to control wheel hop.
I also ran a [email protected], and a [email protected]

I know I'll get 11s before the summer is over..

 

[GNSNAKE]

tune

so did you give on the tune thing:shrug:
thank you for all the shmitt you are doing:beer:
i want to mod my boss


thanks rob

 

[Dadz500]

Nice numbers. I can't wait to see what I can run with mine. Not expecting much as I have very little experience at the track, but will be fun and I am sure I will learn some stuff when there.

 

[Unrealford]

so did you give on the tune thing:shrug:
thank you for all the shmitt you are doing:beer:
i want to mod my boss


thanks rob

Heres what happened to using a aftermarket Tune.
SCT Failed me BIG TIME.

http://www.svtperformance.com/forums/2012-boss-302-mustang-373/874505-my-boss-sct-trouble.html

 

[Red Turtle]

This Friday I went to track and ran my quickest time.

12.15 @111 in 1/4

7.68 @ 89 mph in 1/8

60 ft= 1.62

My Boss is stock except MT Drag Radial 275sx15 and Steeda UCA to control wheel hop.
I also ran a [email protected], and a [email protected]

I know I'll get 11s before the summer is over..

What was the reason for higher mph on the other two runs?

 

[NJSP117]

Nice numbers! You'll be in the 11s in no time!!

 

[P49Y-CY]

congrats, great times! :beer:

 

[Unrealford]

What was the reason for higher mph on the other two runs?

I believe a little wheel spin and better track temps.

 

[brianjh20]

Hey Shaun! I'm Brian I ran against Shaun. I ran the 12.9. I missed 3rd gear that run.
I ran a 12.55 @ 111mph and 12.58 @ 114mph

60 - 1.98 2.00
330 - 5.44 5.48
1/8 - 8.22 8.26
1/4 - 12.55 12.58
mph - 111.13 113.62
This was on street tires with the following mods:
Dynatech Drive Shaft
Jegs Cat Delete
Borla mufflers
1/2 drilled disks for side exhaust - insanely loud wide open with cat delete!
AED - performance/idle tune

I shifted at 7500 had Rev limit set for 7700.
Before next time at the track I plan to install LCA maybe UCA too. My wheel hop was terrible. Although on my 12.58 run I launched very soft just under 2k rpm and did not spin. I also plan to increased my Rev Limit to 8200 after reading this forum.
Any tips guys?
Nice runs Shaun!

 

[Unrealford]

Hey Shaun! I'm Brian I ran against Shaun. I ran the 12.9. I missed 3rd gear that run.
I ran a 12.55 @ 111mph and 12.58 @ 114mph

60 - 1.98 2.00
330 - 5.44 5.48
1/8 - 8.22 8.26
1/4 - 12.55 12.58
mph - 111.13 113.62
This was on street tires with the following mods:
Dynatech Drive Shaft
Jegs Cat Delete
Borla mufflers
1/2 drilled disks for side exhaust - insanely loud wide open with cat delete!
AED - performance/idle tune

I shifted at 7500 had Rev limit set for 7700.
Before next time at the track I plan to install LCA maybe UCA too. My wheel hop was terrible. Although on my 12.58 run I launched very soft just under 2k rpm and did not spin. I also plan to increased my Rev Limit to 8200 after reading this forum.
Any tips guys?
Nice runs Shaun!

Hey Brian that 12.55 was a great run on street tires especially considering out DA.
Next race on Sept 15th should be like low 70s Ill have my Steeda CAI and Tune and hopefully you will bring TIRES,TIRES,TIRES :bash:

 

[brianjh20]

Shaun when are you going to step up to an AED tune?

 

[da5deuce]

Aren't the mph a tad bit low for that e.t.? Either way nice run OP. Nice 60ft also.

Sent from my tuna boat note using Tapatalk 2

 

[Unrealford]

Aren't the mph a tad bit low for that e.t.? Either way nice run OP. Nice 60ft also.

Sent from my tuna boat note using Tapatalk 2

Ya I was pretty surprised seeing such a low mph, my other runs 12,26 was 113 ,7..

 

[Unrealford]

Shaun when are you going to step up to an AED tune?

I gotta get SCT to fix there tuner I don't want to be stranded again..