Looking for gasket for 03 Cobra to install CAI to maf

[KenCobra03]

I'm going to NEDT on 9/27 to dyno bone stock.
Then going back to NEDT on 10/4 to dyno with
my Amazon Racing Stage 1 CAI. I need a gasket
to seal between the cai and the stock maf. I don't
want to use any liquid sealant in there.Where can
I locate a gasket to fit? Bonnell Ford couldn't find
a gasket from a 01-02 Lightning to fit there.
What should I do? Ken

 

[lightninmike]

there is no gasket on the L

 

[bassin247]

I'm not using a gasket. If you want to be crazy about it you have 2 options. Use silicone or get a 6x6 piece of rubber and make one yourself.

Ken, Why don't you swap the cai on the dyno. Slip dean an extra few bucks. If you do that, you will be dyno'n with the same outside temp. You might want to do 1 stock pull and do 2 cai pulls that way the car doesn't get too hot. I wouldn't go twice. If you want, I'll do it for you. It should take 5-7 minutes.

 

[KenCobra03]

It's funny that Jeff's '03 has a gasket on his Steeda CAI.

 

[bassin247]

Buy some gasket material and make one, or get some silicone and seal it up. You will be fine without one.