• Welcome to SVTPerformance!

Looking at '13-14 SCabs

Discussion in 'SVT Raptor Talk' started by Jefe, Oct 16, 2018.

  1. Jefe

    Jefe Well-Known Member Established Member

    Messages:
    17,957
    Joined:
    Mar 24, 2006
    Location:
    AZ
    Looking to pick up a white 6.2L '13-14 SCab Raptor mainly for the HIDs and potentially lower mileage. Found one in Michigan, these photos concern anyone else? 59K miles

    Im seeing prices anywhere from $33K - $40k. Some guys still holding out hope on the higher end?

    fEReBkn.jpg
    YvURLCn.jpg
    sK7ssxY.jpg
    IpZcThK.jpg
    43628065266.491482582.IM1.02.1000x713_A.1000x713.jpg
     
    Last edited: Oct 16, 2018
  2. BlksvtCobra01

    BlksvtCobra01 Well-Known Member Established Member

    Messages:
    9,969
    Joined:
    Apr 10, 2008
    Location:
    Kettering, Ohio
    DriftwoodSVT and Zemedici like this.
  3. DriftwoodSVT

    DriftwoodSVT Raptor club member Established Member

    Messages:
    6,331
    Joined:
    May 27, 2006
    Location:
    Driftwood, TX
    Check the cab corners and drains channels down under the doors. My 2012 SCAB was a TX truck and still had rusted out rockers. Covered under warranty but was in the shop 3 different times to fix the same issue. After 5 years, dumped it for my 2018.

    They had to cut out the rockers, weld in replacements and repaint. Very long process.

    Rust again_02.jpg 20161021_111349.jpg
    Repair picture 2 - after weld.JPG
     
    Last edited: Oct 16, 2018
    BlksvtCobra01 likes this.
  4. Curt@injected

    [email protected] Authorized Vendor Authorized Vendor

    Messages:
    177
    Joined:
    May 5, 2015
    Location:
    Kennesaw, Ga
    I'd stay away. I hate rust.
     
  5. Jefe

    Jefe Well-Known Member Established Member

    Messages:
    17,957
    Joined:
    Mar 24, 2006
    Location:
    AZ
    So inside the door jams?
    and under the rockers?

    Damn thats crazy
     
  6. BlksvtCobra01

    BlksvtCobra01 Well-Known Member Established Member

    Messages:
    9,969
    Joined:
    Apr 10, 2008
    Location:
    Kettering, Ohio
    If that’s a Michigan truck aka rust belt and salt look it over with a fine tooth and comb.


    Sent from my iPhone using Tapatalk
     
  7. Jefe

    Jefe Well-Known Member Established Member

    Messages:
    17,957
    Joined:
    Mar 24, 2006
    Location:
    AZ
    The price is amazing but I would have to fly out to see it and then ship it home. As cheap as it is I could replace/clean up a lot of that stuff.

    I drove this one last night and its 20 mins from my house. Method Wheels with SVT center caps, lightbar in the grill, blacked out accents all over, Hellwig sway bar, Corsa exhaust, Pedal Commander, 65K miles but asking $40K. Lots of small front bumper chips but it was extremely clean. The Corsa start up is amazing! MPG said 14.9 haha. I think he reset it and babied it for a few days

    00A0A_gRgX0bd4VB3_1200x900.jpg
     
    BlksvtCobra01 likes this.
  8. BlksvtCobra01

    BlksvtCobra01 Well-Known Member Established Member

    Messages:
    9,969
    Joined:
    Apr 10, 2008
    Location:
    Kettering, Ohio
    Good luck with whatever you decide. The Raptors are sharp. Next spring I plan on putting either Bora or Corsa on my FX4 F-Juan Fiddy.


    Sent from my iPhone using Tapatalk
     
  9. Jefe

    Jefe Well-Known Member Established Member

    Messages:
    17,957
    Joined:
    Mar 24, 2006
    Location:
    AZ
    Also came across this bad boy but its a little out of my budget. And the 46" tires would be a pain...

    39132498_594844880912221_3918631635775389696_n.jpg?ig_cache_key=MTg1Mzc3MDc3MTEzNjQ1ODAzMQ%3D%3D.jpg
    2851023_1578637245615454_5390556100857773615_n.jpg?ig_cache_key=MTg4NjUwNjUwOTM2MjMzOTkwMQ%3D%3D.jpg
     
  10. DriftwoodSVT

    DriftwoodSVT Raptor club member Established Member

    Messages:
    6,331
    Joined:
    May 27, 2006
    Location:
    Driftwood, TX
    46"s would be fun!
     
  11. Jefe

    Jefe Well-Known Member Established Member

    Messages:
    17,957
    Joined:
    Mar 24, 2006
    Location:
    AZ
    Appears Im trying to find a unicorn. Less than 5 in my 2 week search and all but 2 are back east. I should have bought one years ago!

    How many SCabs were made vs SCrews?
     
  12. DriftwoodSVT

    DriftwoodSVT Raptor club member Established Member

    Messages:
    6,331
    Joined:
    May 27, 2006
    Location:
    Driftwood, TX
    Around 5% are SCabs, from the numbers I saw on the ford raptor forums.
     
    Jefe likes this.

Share This Page