I'm doing some work on a customers car, it has a Kenne Bell SC on it, and has had a lot of work done. Do you all typically replace the SC to lower intake manifold gasket every time you pull the SC or is it reusable?
Also, the previous shop installed the fuel injectors, but didn't install any of the injector clips in the fuel rail. Is this normal? I am about to order new clips, but wanted to make sure there wasn't some reason that they should be left off.
Finally, I have noticed in a couple of these terminator engines, the coolant flange that feeds the intercooler, where the O-rings are located on the two tube adapters, have a bunch of RTV on them. I would always swap the O-rings, but since it looks like both engines had RTV around the O-rings and on the flange surface of the coolant flange, I wondered is this typical? I would think maybe a little on the flange gasket, but with new O-rings no extra RTV should be required, but maybe its just for insurance?
I appreciate any advice as to what others find as best practices on these areas.
Thanks...
Also, the previous shop installed the fuel injectors, but didn't install any of the injector clips in the fuel rail. Is this normal? I am about to order new clips, but wanted to make sure there wasn't some reason that they should be left off.
Finally, I have noticed in a couple of these terminator engines, the coolant flange that feeds the intercooler, where the O-rings are located on the two tube adapters, have a bunch of RTV on them. I would always swap the O-rings, but since it looks like both engines had RTV around the O-rings and on the flange surface of the coolant flange, I wondered is this typical? I would think maybe a little on the flange gasket, but with new O-rings no extra RTV should be required, but maybe its just for insurance?
I appreciate any advice as to what others find as best practices on these areas.
Thanks...