I did this install in 2009 but never put up the pictures. Here they are. I mounted the driver underneath the speaker deck. This is the Zone5 triple pump driver. I have the Fore triple pump hat with 3 Ford GT pumps in it. All parts from Lethal Performance.
Not sure if Zone5 is still making this so this post may be irrelevant. Put perhaps could demonstrate a way to mount the Kenne Bell BaP to save space.
Its a little more time consuming and hard on the back mounting it this way but well worth it in the end as it is totally out of the way. I did this by myself and was difficult holding the driver up there for mock up and alignment. If you can get an extra set of hands or make a cardboard template of the base of the driver so you dont have to hold it in place when you mark the holes it will be a little easier.
/
/
/
/
/
/
/
/
/
/
Not sure if Zone5 is still making this so this post may be irrelevant. Put perhaps could demonstrate a way to mount the Kenne Bell BaP to save space.
Its a little more time consuming and hard on the back mounting it this way but well worth it in the end as it is totally out of the way. I did this by myself and was difficult holding the driver up there for mock up and alignment. If you can get an extra set of hands or make a cardboard template of the base of the driver so you dont have to hold it in place when you mark the holes it will be a little easier.
/
/
/
/
/
/
/
/
/
/
Last edited: