I've finally got around to finishing up the EATC install on the Lightning. There are 21 wires coming out of the climate control box, and of those, 9 of those connect to three sensors (sunload, ambient air temp, and in cab air temp), so those are easy enough to figure out. That leaves me with 12 wires separating me from having climate controlled AC in the Lightning. I don't have a steering wheel with AC controls, so I can eliminate that wires too - down to 11. As you can guess - August in southwest FL is pretty hot, so I'd like to knock these last 11 wires out.
I need help finding where to tap in for these last 12 wires. Even if I only get a few a day, it'll get me done pretty quickly. Here are the diagrams (so generously provided by Eric - thanks so much):
Of all of these wires, here are the wires yet to be connected:
Pin #11 - A/C Pressure Cutoff Signal
Pin #14 - Instrument Panel Lamp Feed
Pin #22 - Relay to Auxillary Control
Pin #23 - Blower Control Output (PWM)
Pin #1 - SPC (-)
Pin #2 - Power (Hot at all times)
Pin #3 - Ground
Pin #15 - SPC (+)
Pin #16 - Power (Hot in run)
Pin #17 - Blower relay
Pin #19 - Front Panel Illumination
I'll update this original post to scratch off each wire as I find it's home. Any help is greatly appreciated.
I need help finding where to tap in for these last 12 wires. Even if I only get a few a day, it'll get me done pretty quickly. Here are the diagrams (so generously provided by Eric - thanks so much):
Of all of these wires, here are the wires yet to be connected:
Pin #11 - A/C Pressure Cutoff Signal
Pin #14 - Instrument Panel Lamp Feed
Pin #22 - Relay to Auxillary Control
Pin #23 - Blower Control Output (PWM)
Pin #1 - SPC (-)
Pin #2 - Power (Hot at all times)
Pin #3 - Ground
Pin #15 - SPC (+)
Pin #16 - Power (Hot in run)
Pin #17 - Blower relay
Pin #19 - Front Panel Illumination
I'll update this original post to scratch off each wire as I find it's home. Any help is greatly appreciated.