guys who did your own IMRC Deletes. quick question/help needed

[97cobra1]

How did ya'll close the holes up? jb weld, welding them? apparently the welder for the shop it's at "doesn't have time" or some other dumb excuse so now i either have to find a place to weld them, which i have no idea of anyone, or i've seen that people have used jb weld but i'm iffy on that.

I know i'm asking a lot for a forum but some quick answers would be great as im on my was to pick it up now.

 

[TERMINATED97]

weld them

 

[mwolson]

I had mine TIG welded.

 

[dynamo]

Here is an option.
I unscrewd the plates from my rods and left the rods in place,
i did not want to take chance of somthing leting loose.

 

[98 N/A 4V]

I used JB weld Industro. Has a head threshold of over 550*F. I did mine over 10yrs ago and they are still holding up just fine.

 

[crazycarlo]

I used JB weld since I used the plastic imrc's and they held up great even under boosted conditions.

 

[CJK440]

JB weld is fine if you prep the holes properly. Don't bother filling the hole between the oval,square port of the same cylinder.