Full bolton, how much after ported blower?

[Mr.Venom]

Good day everyone,

I apologize if my question has been answered before but I couldn't find anything conclusive last night. :read: With the current mods in my sig, I'm interested what I could pickup with a ported blower, port matched accufab SBTB and accufab plenum over my stock setup with a 2.76 upper.

The results I usually find are people doing many boltons including an upper and lower at once with the port and sometimes in pieces. Also my lower is stock. Well my question is what I can hope to pickup with just adding a port, TB and plenum. Thanks in advance :rockon:

Kyle

 

[Grimster]

stock fuel injectors?

 

[mig4236]

I pushed 490rwhp with posi supercharger 2.76 and stock lower, lfp tb, ported plenum.

Sent from my SGH-T999 using Tapatalk 2

 

[Mr.Venom]

Did you do your boltons all at once mig? Also do you have longtubes?

Grim, yes stock injectors right now.

 

[gabe1530]

You should be around the 490-505 area. To maximize the setup I would add a lower.

 

[IronTerp]

Obviously, it will vary from car to car, but a typical blower port will result in about a 40 RWHP gain and the throttle body setup will give you about 10-12 horsepower. With the appropriate tuning, you should be real close if not right at 500 RWHP.

 

[05satinGT]

Are the 496/491 numbers in your sig correct for the current mods?

You'll need injectors and a maf too. Usually upper only ports make 500-505ish rwhp, the numbers seem a little high for your current ones for a non-ported car.

 

[badazzebz06]

Ur car will be a serial rapist

 

[SYMach1]

Do it right...add supporting mods and a lower...you will put 520-530hp/520-550tq

 

[horspla2000]

60#ers, 4# lower, Mafia,SC port, BAP, Accufab SBTB and plenum......... DO IT!