FS: Posi ported TVS

[rlhay2]

]It has been a beautiful relationship:
reliable
powerful
fulfilling

10's in the 1/4 mile in street trim on pump gas.

Capable of 650 reliable rwhp with supporting mods.

But I think it is time to move on, so:

I am ready to remove the TVS from my car.

Here are the pics I have to show the current setup:

I can provide better photos if desired.

$3500 for the ported TVS, VMP stock look 2.65 pulley, VMP large elbow inlet and FRPP 65mm throttlebody.

Less than 6000 miles on the TVS and pulley.
Less than 1000 miles on the throttlebody.

As soon as these are sold, I am purchasing a Whipple.
Feel free to contact me via the forum or email: [email protected]
As all the parts are currently still on the car, test rides can be given!

 

[me32]

how much for just the CJ 65mm TB with all Electronics thanks

 

[rlhay2]

how much for just the CJ 65mm TB with all Electronics thanks

If I am to part it out, the TVS would have to sell 1st.

 

[zporta]

Then how much for the tvs and inlet?

 

[rlhay2]

Then how much for the tvs and inlet?

$3200 for Posi ported TVS w/2.65 pulley and VMP D-port elbow

 

[CuZzO99L]

so ur car made 621 on the stock lower? Just trying to see if this would be worth while investment givin the hp level Im already at....

 

[rlhay2]

so ur car made 621 on the stock lower?

Every dyno is different. Thus it is hard to compare absolute numbers.

With Eibach R1 coil-overs and M&H drag radials it has run 10.80's in the 1/4 mile at 130 mph on 93 octane pump gas. With the shaker 1000 and me in the car that is just over 4100 lbs.

 

[blkGT500nCA]

Free bump. Good luck with the sale.

 

[me32]

Good luck with the sale

 

[black99lightnin]

subscribing.

 

[VNMOUS1]

Bump-o-rama for Ronnie


bj

 

[rlhay2]

Christmas price reduction!

$3500

Although that Zex blackout kit is looking more and more interesting...

 

[me32]

Pm sent

 

[rlhay2]

Pm sent

Still available.

 

[lucheski]

how much did you pickup from the port?

 

[rlhay2]

how much did you pickup from the port?

The port work was done with a series of other mods. Hard to say how much each mod contributed.

 

[NeoTokyo]

How much for just the SC, pulley and elbow?
For the swap that I am doing thats all that I can use.