Hi everyone, need some help again.
I’m in the process of installing more wiring harnesses, and have a few questions.
-First question pertains to the transmission harness that contains the plugs for the output shaft speed control, and reverse lights plug (push pins to the driver side of trans, then runs up behind where top of trans meets the engine / behind lower intake against firewall.
The other end of this harness contains the two plugs for the O2 sensors.
The larger plug which I labeled that has the inner red color (pic 1), I see it connects to the male end that is wired to a different loom that carries wiring for the injectors, throttle position sensor, and coil packs, and EGR connections. But the two harnesses also contain the green plugs, each on a separate harness (pic 1). Where do the green plugs connect?
Pic 2 and 3, the black plug with the red inner portion (labeled “L”), where does this connect? Then the stud below that off the upper intake (labeled “F”), what connects this? It is right below where the idle speed control mounts.
Lastly, pic 4 and 5, the harness (circled in red), is loomed to the plug in my hand, then routes down through the engine valley and ends up by the back of the lower intake (pic 5 - in my hand). Any direction on these two plugs?
I apologize if this is a bit much, but any help would be appreciated.
-Ronald.
I’m in the process of installing more wiring harnesses, and have a few questions.
-First question pertains to the transmission harness that contains the plugs for the output shaft speed control, and reverse lights plug (push pins to the driver side of trans, then runs up behind where top of trans meets the engine / behind lower intake against firewall.
The other end of this harness contains the two plugs for the O2 sensors.
The larger plug which I labeled that has the inner red color (pic 1), I see it connects to the male end that is wired to a different loom that carries wiring for the injectors, throttle position sensor, and coil packs, and EGR connections. But the two harnesses also contain the green plugs, each on a separate harness (pic 1). Where do the green plugs connect?
Pic 2 and 3, the black plug with the red inner portion (labeled “L”), where does this connect? Then the stud below that off the upper intake (labeled “F”), what connects this? It is right below where the idle speed control mounts.
Lastly, pic 4 and 5, the harness (circled in red), is loomed to the plug in my hand, then routes down through the engine valley and ends up by the back of the lower intake (pic 5 - in my hand). Any direction on these two plugs?
I apologize if this is a bit much, but any help would be appreciated.
-Ronald.