E85, Who has it? What all do i need?

CamdZ06

Member
Established Member
Joined
Aug 2, 2010
Messages
423
Location
Bloomington,IL
Since i bought my car I was always interested in changing the pulley and tune to E85. What all do i need to do it and how much hp/tq gains on average should i see?

Here are my fuel modifications.

FUEL:
-60 lb. matched fuel injectors
-SCT 2400 MAF
-Lethal Performance twin FPDM set up with 40 amp relay and dedicated 8 gauge feed wire / 10 gauge pump wire.
-Fore Precision billet twin fuel hat with twin GT pumps wired with custom water tight connectors
Fragola push lock 8AN braided fuel line from fuel hat to Aeromotive 10 micron inline fuel filter and 8AN line from filter to fuel rails
 

Torrance

Shenanigans!
Established Member
Joined
Oct 13, 2011
Messages
945
Location
Upton, KY
Sounds like you could probably get an E85 tune, but I'm guessing you may run out of injector.

What combo do you have already, to make the numbers in your Sig?
 

CamdZ06

Member
Established Member
Joined
Aug 2, 2010
Messages
423
Location
Bloomington,IL
Sounds like you could probably get an E85 tune, but I'm guessing you may run out of injector.

What combo do you have already, to make the numbers in your Sig?

Thanks for the reply. Currently i'm at 18 lbs with a 3.1" Reichard Racing pulley, W/ all supporting mods, plus a few custom cooling mods. Its been dynoed twice, When i bought it at 585rwhp/549rwtq and that was without the aftermarket exhaust and mid pipe. Currently put down 601RWHP/578RWTQ.

the distillery section is where you will find all your answers .. fyi.

Thanks, i will check that out!
 

Users who are viewing this thread



Top