dynojet wideband ?

[Dirk]

I just installed the latest Dynojet Wideband Commander with Analog gauge.
It works great so for, at least the AF ratio reading.

Is there a way to dim the gauge backlight?
Because it is triggered from the wideband and not external.

What’s about the gauge warning light, is it set from the factory or can it be set ?

 

[03cobra#694]

I just installed the latest Dynojet Wideband Commander with Analog gauge.
It works great so for, at least the AF ratio reading.

Is there a way to dim the gauge backlight?
Because it is triggered from the wideband and not external.

What’s about the gauge warning light, is it set from the factory or can it be set ?

You`ll have to hook-up the guage lighting to Fuse #37 in the fuse block(Dash guage dimming)w/a add-a-circuit.I think you have to set the warning light,I never set it on mine.I didn`t think I needed it.

 

[Dirk]

I found the way to set the warning light, there is also a beep sound which I would like to turn off.

I didn't find the way to hook up the guage lighting, it gets it's power from the wideband.

 

[BO TY KLR]

Had mine in for a few years now, so it may be an older design. But my backlight adjust with the gauge lights. I also don't have a beep, wish it did though. Try their website, it was very informational when I first got mine in. May aswer a few questions for you.

 

[03cobra#694]

I found the way to set the warning light, there is also a beep sound which I would like to turn off.

I didn't find the way to hook up the guage lighting, it gets it's power from the wideband.

You`ll have to wire the guage lighting seperate from the w/b.I used #37 in the fuse box.

Here is the DJWBC install guide link.
http://www.widebandcommander.com/pdf/WBCInstallGuide.pdf