Drag Results 5-10-07 Terminator

[Ubergeist]

Well no 12's for me.

Didn't even improve on my best of [email protected] stock. Since then I have added a MGW shifter, and BF IRS brace.

My best run was

60'---2.190
330'--5.810
1/[email protected]
1000'-11.198
1/[email protected]

I was pretty consistant now however, I only missed one shift out of my few runs. And we have that run on the video vs a GT500.

A stage3 SRT owner(Redbull) and I got there at 9am, and did some runs. My traps were 108-109ish, his were 110-112.


On a side note, there was a new z06, his best was 12.6@120, a lightly modded C5 Z06 best was 12.8@112, and a new GT500 ran 13.1@117 all stock against me.

Also regular C5 corvettes were running higher 13's@102-103.

I was going to run the GT500 one more time since I missed 3rd on that run. But shortly after a nova flipped and Redbull and I were sick of waiting for clean ups so we left.
Redbull and I lined up 7 times at the drag strip. I took him 4 out of 7.

Drivers race. Stage 3 SRT-4 off hom vs stock Cobra.
All and all it was a good outing.

We also did a run on the highway. It was a standstill.

 

[SVTkel]

Once you get your 60' to 2.0 or less you will be in the 12's.

Oddly my 3rd - 4th shift is also the slowest shift as it is almost like there is a pause in the middle.

Also it looks like everyone was in the same boat regarding the off times so not too bad overall.

 

[P49Y-CY]

they can be tough to get down the track thats for sure

i take it you are still on stock intake/exhaust and tires?

 

[Knoxville COBRA]

What would a 8.879,85.77 mph w/2.245 60 ft. time come out to in a 1/4 mile?

 

[Almo]

8.87 = 13.50s to 13.60s in the 1320.

 

[Alb Cobra]

Ubergeist what are you launching at? I run on street tires and after a lot of trial and error I was able to cut consistant 2.1's and below lowest being a 2.000 when I was stock and exhaust/intake. Try launching at 3000rpm and slipping the clutch.

After the pulley install I had to learn all over again how to launch. I only recently have had troble with the 2-3 gear shift. I got a fiore clutch quadrant kit and firewall adjuster coming in. Do a search in the Terminator treads for "missing 2-3rd" they also tell you how to adjust your stock quad in these treads seems to help out a great bit.