car wont stay running

[71catruck]

So I had a code for the form so I replaced it. Car drove fine for a few hours then dies again and I get 3 codes
P0190 fuel rail pressure a (FRP-A) ckt
P0193 fuel rail pressure a (frp-a) ckt high input
P1233 fuel pump driver module disabled or offline (fuel pump driver module)

Any ideas guys

 

[71catruck]

So i let it sit for A few min. Re load the tune start it again and it runs for a few min. Then dies only code is p0190

 

[71catruck]

the car has an 03 hat with stock pumps 40 amp BAP and the fuel filter was changed 7000 miles ago

 

[SNK-BITE]

Have you checked your FRPS?

 

[71catruck]

thats what im thinking it is. but how do i check it. i made sure the electrical and vacuum were plugged in good.

 

[CobraBob]

This thread explains how to check your FRPS.
http://www.svtperformance.com/forums/engine-tuning-214/649037-there-way-test-frps.html

If it's bad, replacing the FRPS is very easy. Pop it off. Pop it on.

 

[CobraBob]

Oh, and here's a link from my Terminator FAQs showing where it is located, just in case you didn't know where it was. FRPS Photo

It's very easy to change.
1. Pop off the sensor on top.
2. Unscrew the screws.
3. Pull it off.

If there's pressure in the rail, you may get squirted, so have a rag ready just in case.

 

[71catruck]

Thanks cobra bob your post are always very complete and help full. I do know were it is though lol.

 

[cobracide]

 

[71catruck]

Kinda confused on why the above pic was posted (i know were the frps is) but ok. I'm sitting in the car and its ideling great for the last 17 min and its up to temp. This is why I'm confused its all stock lines and yesterday really wasn't to hot maybe mide 80 I really shouldnt be getting a vapor lock.