Installed new rotors and pads and when I started to do my break-in procedure, after a few hard brakes something was wrong. Upon inspection, the driver's side caliper was up on one end and the holding pin was gone. I figured maybe the new pin was a tiny bit smaller so tried an old one. but it did the same thing. This didn't happen with the previous pads, but then again, those were regular street pads and I probably never braked as hard as trying to bed these XP10s.
I've ordered a new caliper bracket to see if that fixes it, but curious if anyone else has seen this happen.
I've ordered a new caliper bracket to see if that fixes it, but curious if anyone else has seen this happen.