Finally finished off the stock axles last night. it's bent severely.
I have moser 31 spline c-clip axles on order and they will be here tomorrow.
what I need to know is what ARP stud can I use with these. it specifys .625 knurled so I got that. I know they are 1/2-20 thread.
I want to retain stock lug nuts, so I don't want a set that will bottom out in the lugnut and be too long.
what LENGTH .625 studs should I get? also is there a specific KNURL length? most I've seen were .400 knurl length?
Just want to get this all setup with no hangups. thanks in advance.
I have moser 31 spline c-clip axles on order and they will be here tomorrow.
what I need to know is what ARP stud can I use with these. it specifys .625 knurled so I got that. I know they are 1/2-20 thread.
I want to retain stock lug nuts, so I don't want a set that will bottom out in the lugnut and be too long.
what LENGTH .625 studs should I get? also is there a specific KNURL length? most I've seen were .400 knurl length?
Just want to get this all setup with no hangups. thanks in advance.