ARP stud length for Moser 31 axles??

[VFORCEJOHN]

Finally finished off the stock axles last night. it's bent severely.

I have moser 31 spline c-clip axles on order and they will be here tomorrow.

what I need to know is what ARP stud can I use with these. it specifys .625 knurled so I got that. I know they are 1/2-20 thread.

I want to retain stock lug nuts, so I don't want a set that will bottom out in the lugnut and be too long.

what LENGTH .625 studs should I get? also is there a specific KNURL length? most I've seen were .400 knurl length?

Just want to get this all setup with no hangups. thanks in advance.

 

[VFORCEJOHN]

this is what I DO NOT want.

 

[BOSSPOWER]

Call Van, I got my Mosser's installed this week and went with the Dorman's studs which allow us to use the stock lug nuts.

Regards,

Manuel

 

[shetheri]

Steeda sells a 2.5" ARP wheel stud that fits the stock lug nuts. These are made specifically for Steeda so they are the only place you can get the reduced length ARP's. The regular ones are 3". I just installed these and they work perfect.

 

[Tob]

These are what I used but you want a short stud with a closed lug. I wanted a better stud that didn't have to be short.

I think it worked out rather well.

From here.

 

[TORQJNKY]

I used 1/2 x 20 x 2" studs from Strange when I bought my 31 spline axles from them and I reused the stock lug nuts. If you need pics, let me know.