The firewire instructions say orange for the input and blue for the ground. Voltage = 0. Then SCT says to connect the system ground wire (black). Voltage still = 0.
I look at my x4 users manual pdf file and it says this in quotes and caps:
"YOU WILL ONLY BE USING THE RED AND BLACK WIRES - CONFIGURE AS ANALOG 7 IN YOUR X4."
I tried this. Voltage = ~7.6 (with no conversion formula). To confirm / deny this, I used my old hardware, Xcal2 interface, Livelink 6.5, and with no formula, Voltage = 4.5, what it should be.
I'm at a loss. Thoughts or experiences appreciated.
I look at my x4 users manual pdf file and it says this in quotes and caps:
"YOU WILL ONLY BE USING THE RED AND BLACK WIRES - CONFIGURE AS ANALOG 7 IN YOUR X4."
I tried this. Voltage = ~7.6 (with no conversion formula). To confirm / deny this, I used my old hardware, Xcal2 interface, Livelink 6.5, and with no formula, Voltage = 4.5, what it should be.
I'm at a loss. Thoughts or experiences appreciated.