My suspension mods are H&R Race Springs, Steeda Bump Steer and Steeda 3 bolt C/C plates. Had it aligned today and found a couple of interesting items...
I had installed the C/C plates with the bolts through the longer slots. The lowest the Camber could be adjusted to was -1.7 degrees (on the left side). The right would go lower, but they went ahead and matched the right side (-1.6 degrees).
Caster was set at 4.0 degrees
Toe was set at .12 degrees
Rear camber is at -0.9 degrees
and toe is at .12 degrees.
Thrust is 0
Does this look ok? Or is the Camber too aggresive on the front? I am a rookie when it comes to the suspension stuff, so any help is appreciated
I had installed the C/C plates with the bolts through the longer slots. The lowest the Camber could be adjusted to was -1.7 degrees (on the left side). The right would go lower, but they went ahead and matched the right side (-1.6 degrees).
Caster was set at 4.0 degrees
Toe was set at .12 degrees
Rear camber is at -0.9 degrees
and toe is at .12 degrees.
Thrust is 0
Does this look ok? Or is the Camber too aggresive on the front? I am a rookie when it comes to the suspension stuff, so any help is appreciated