Have a 2.2KB I was going to swap to the later gen 2 snount.
(Had a parts blower to steal it from)
I see they are vastly different.
To put the gen 2 snount onto the blower that had the gen 1 I assume I need to get swap the blower side coupler as well?
I hit it with the impact on normal left to loosen and the Allen bolt didn't budge. Where I stopped off at. Is it possibly reverse threaded?
Any insight is appreciated.
(Had a parts blower to steal it from)
I see they are vastly different.
To put the gen 2 snount onto the blower that had the gen 1 I assume I need to get swap the blower side coupler as well?
I hit it with the impact on normal left to loosen and the Allen bolt didn't budge. Where I stopped off at. Is it possibly reverse threaded?
Any insight is appreciated.