Im in the process of installing a ported blower, 2.8pulley, and new maf sensor. I gonna leave the stock injectors for now and see what the a/f looks like on the dyno. But my qestion is how to get they, the car started bone stock, so it has complety stock tune. Is it safe to drive to the dyno/tuner about 40minutes away or should i trailer it?
1st time build Q's
- Thread starter slowsi
- Start date
Drive it and don't go into boost and you'll be fine.
You aren't going to just check the tune and you're going to get a custom tune correct? If so you're going to be one very surprised owner lol with all the new power.
You aren't going to just check the tune and you're going to get a custom tune correct? If so you're going to be one very surprised owner lol with all the new power.
Last edited:
Leave the stock MAF on the car until you get to the tuner. It only takes a minute to put the new one on and the car will drive much better until you get there.
If you put the new MAF on without a tune, it throw the A/F way off.
And Stay Out Of Boost! Like Brian mentioned.
If you put the new MAF on without a tune, it throw the A/F way off.
And Stay Out Of Boost! Like Brian mentioned.
No Boosty...youll be fine. its hard i did it for about a hour and half drive lol
Users who are viewing this thread
