My ABS light came on a while back, I tested the two front sensors and from my results I found that the front passenger side was bad, I tested using a multimeter and spinning the wheels at 1 rev per second, the volt readout for the passenger side was bad.
SO, I put the new sensor in today and the light is still on, I unplugged the battery for 5 minutes and then still the light stays on. So I want to test the rear abs sensors, how do you get to the connector for the rears? I followed the cable from the sensor and it leads up into the body under the rear seats through a rubber grommet. Do I need to take the rear seat out to get to the connector?
Any help would be appriciated.
SO, I put the new sensor in today and the light is still on, I unplugged the battery for 5 minutes and then still the light stays on. So I want to test the rear abs sensors, how do you get to the connector for the rears? I followed the cable from the sensor and it leads up into the body under the rear seats through a rubber grommet. Do I need to take the rear seat out to get to the connector?
Any help would be appriciated.