Anyone know if the Lightning Whipples use the same pulleys as the Whipple Cobras?
Specifically I found a 4" upper pulley from a 2.9L Whipple Lightning and I am looking for a 4" for my 03 Cobra 3.4L
Fuel pump questions/issues
03 Swap into 02 GT (possible fuel pump or pumps failure or going bad)
Mods include:
Stock blower
2.9 pulley
Kooks Longtubes and H pipe
Single blade tb
JLT short CAI
Lund Tune
(75k miles)
Stock tank
stock pumps
Stock FPDM with wire upgrade/relay
1) Was...
This car started its life with me about 4-5 years ago when a friend gave up on the restoration after a few bugs were showing their ugly heads. Some of you have seen it from time to time im sure.
The car is a 1987 Mustang LX 2dr sedan better known as the Coupe or Trunk car during the 79-93...
Looking to buy a 96-98 Cobra C&L Cold air intake pipe. Really just need the Throttle body to mass air and one with the strut tower brace clearance.
C&L fits my needs the best...or supercharger piping that you may have not used. Such as Vortech or paxton.
Text me at 336-257-9101 Thanks Rob
Ive run into some issues with the rails I have. My fuel pressure regulator will not seal off it seams to be Bent up. So if anyone has an extra set laying around and would like to sale theirs please in box me or text me at 3362579101
Thanks Rob
My Fuel Pressure regulator started leaking like crazy, I think the issue is the O ring at the FPR, anyone know where or what size it is to get it replaced?
thanks Rob
Just curious about this modified heater tube...I purchased this engine to do a mod swap and I do believe the lines will work out fine because of the location of the heater core, just curious if theres anything I should change before I install and what is the sending unit for? Assuming thats what...
I have a brand new set of tubular a arms for sale, these a arms were purchased brand new, I was going to use them on my Foxbody but I don't like the wider wheel base for my street car.
These are 96-04 Qal tubular a arms with the sway bar mounts
I installed them on my car but it hasn't...
These came on an engine I purchased for a project. I wasn going to use them but found a set of longtubes thst fit my needs better.
As you can see the ceramic coating is starting to come off , I was going to redo them, but I will go ahead and throw them up for sale. To see if anyone has...
I'm looking for a set of Maximum motorsports lower rear control arms with the adjustable spring perches.
Please let me know if u know of a set. Thanks Rob
Text is best 3362579101