Trying to understand with this tool if you would suction/fill at the coolant crossover port or at the expansion tank?
https://www.svtperformance.com/threads/tool-for-coolant-refill-with-vacuum.944650/
SOLD SOLD SOLD
This is a new in box VMP gen3 2.65. It will come with the GT500 elbow and TB.
Never installed and can take more photos upon request.
Thanks for looking
Hello again everyone,
I’ve seen some older posts about the 2.66 vs 2.97 magnum gearing consideration and was wondering if anyone using a 2.97 had feedback or comments to their swap.
I talked to one guy that went 2.97 and immediately sold it for a 2.66 but also heard folks on the opposite end...
Hi again Bs and Gs,
Who or what shop is the “go to” for having a motor built? I’ve talked to a few shops and have been patient but was wondering what the consensus was around here. I’ve seen enough of the threads of where not to go but not any in the positive direction.
Any input is welcomed...
Hey Bs and Gs,
Once again the corona seems to be affecting my car again lollll. For real, not so crazy this time. I’m pretty sure I burned up the clutch packs in the LSD due to the car making a scraping/rubbing noise from the diff only when turning. If it’s not just that then god help me lol...
Hey Bs and Gs,
So I have a photo from my boroscope from November and then again from two days ago. I haven’t gotten on the car or beat it too much since getting it all back together around October. I got the battery light after one little test hit and then didn’t get on it again. I got my...
Hey Bs and Gs,
I got the MS3 plug in play installed but haven’t gotten the can bus widebands installed. Runs super rich.
I was wondering how everyone goes about the power and ground connections. AmpEFI said ground the wideband to the battery but the signal input wires are kind of short and...
Hey Bs and Gs,
Wondering what everyone is running fluid wise in their transmissions?
I have a magnum about to go in and will do the 500 break in miles with some cheaper dex III and then when it comes to the longer term get something better in it.
I've read alot about amsoil ATF being the...
Hey guys,
So I have a question regarding upgrading the ECU and when it’s necessary or appropriate to do so. Basically it’s (Stock ECU + Lean protection module and Vampire knock kit) VS Haltech 2500 Elite.
I currently have a lean protection module and plug n play vampire knock kit from J&S...
Hey boys and girls,
Today I was able to go to two different pumps that have E85 and I tested the fuel. I tried the test a week ago but the results are inconclusive as I messed something up. I redid the test and have the photos to go along with it.
If you have seen my other thread where the...
Hey guys,
I posted this question in another area but seem to get more chatter in this forum.
I was looking to see if anyone had numbers or knowledge for either of these kits. I plan on running a trunk mount intercooler regardless however not sure which one to run.
I was also wondering if I...
Hey guys,
I was looking to see if anyone had numbers or knowledge for either of these kits. I plan on running a trunk mount intercooler regardless however not sure which one to run.
I was also wondering if I should be looking to run 4 gal or 7 gal. It would be a street car so not sure which...
Hello everyone,
I have some questions I hope this fine group might be able to help me out with.
I'm going to go ahead and pick up a Magnum transmission after everything I've seen about it vs the stock T-56. My thoughts are I can keep the stocker as a back up in case something "happens" or if...
Hello everyone,
This past fall I purchased a 01 Bullitt with an 04 cobra swap. It was completed by my uncle 5+ years ago but due to financial situations with him, it has never seen the road. Since owning it, I have put around 1k miles on it and believe I spun a bearing in the motor.
I changed...