Search results

$225.00 Shipped

SOLD

Will take best offers- Someone must want/need this. Taking up space. Let me know. $675 (OBO) Shipped. This has never been installed. $200.00 less if bought new. Want this gone. Brand new (box opened to take pictures) VMP Triple Pass Heat Exchanger with Reische 170 Thermostat* This setup...

Posted before regarding a short block for my 2011. I have also been shopping around for possible complete long blocks to make the swap easier. I am wondering if anyone has heard or actually seen if the later built 2011-2014 Aluminator might have the new 2015 heads? I believe I read that some...

Looking at the doing a shortblock in my car very soon. I am wondering if there are parts beyond the obvious I should replace while I have the engine apart. The car has 22K miles currently. Obvious stuff I am aware of - OPG's Head, oil pan, timing cover (sealant) Fluids Should I be...

Have KW Variant 3's installed for about a month and hear some noises and wondering if anyone else running them might be able to tell me if they are normal. Not sure how to explain other than "squishy" noises... not clanking like a loose sway-bar link. It seems to be on compression so wondering...

Guys, Thought I would post up pics of my friends HPE700 C7 Vette. I understand that Hennessy doesn't have the greatest rep and I am sure there are other cheaper options out there but this car is just baddass. Dynoed 652 RWHP, not sure on torque, car is just silly fun to drive. Uses an...

Guys running a Kenne Bell BAP, have a question. Lately I have noticed that my BAP is making a buzzing noise. It is loud enough that I can hear it in the cabin while driving under load, at idle it is quiet. It did not do this before and concerned it might be going bad. Anyone else have this...

Guys, Just installed the kooks shorty headers and have an issue with the passenger side header angle where it meets the cat. The passenger side with cat bolted on is a good 1 1/2 lower than the drivers side, angles to ground significantly. It is below the frame rail, pretty sure this is not...

Does anyone know if you can buy internal parts for the MT82 from Ford? Things like bearings, gear sets etc? Mine has a terrible whine, can be heard from outside the car and warranty is not an option. Thought I would pull it out of the car and see what is wrong internally. Thanks

Working on install Roush supercharger and need a little assistance. I am currently working on the harness that goes to the PCM connector. The manual states that I need to install wire into empty spot C36. My PCM connector has a wire in this position (Purple/Green). Tried searching with no...

Guys, What prep work would need to be done to engine block with 9000 miles if I swapped out with above mentioned parts? I see a lot of Boss engines holding up to some high horsepower and am thinking this might be a good cost effective option for me. Looking at a Paxton SC later this year and...

Guys, Tried searching various forums and google with no luck on this. I have a 20 Amp BAP I used in a previous car. Can I use this BAP for my 2011 GT or do I need to upgrade to a 40 Amp when I supercharge? Thanks

Just tried to install MM rack bushings in my Cobra and I think they sent me the wrong ones. The packing slip says they are mmst-3's but they appear way shorter than the ones on the MM webpage. Here is link to pictures of the ones from mm and a picture of one I was sent. Can anyone that has...