Search results

i currently have a 97 cobra with a mark 8 fan, car has a vortech supercharger tuned via unknown chip, my fan speeds don't turn on till factory settings. My question is can I add an electric fan controller and not mess anything up ecu,ccrm? Want my fan to turn on sooner already have a napa 180...

Like the title says or if u have the bolt that's circled below. Mine came undone and went MIA.

Like title says a buddy of mine is looking for those parts please tx him at (408)417-4041 thanks

Like title says

Looks like my cheapest route to go with "built" block is a termi shortblock with the rest of my b head parts. I know i would have low compression 8.5:1. I currently have a s-trim with 10lbs of boost. Will it affect my performance that bad? Currently have 3.55s looking to go 4.10s in the near future?

Need help on piecing a new forged shortblock. I spun a rod bearing and chipped pieces off a piston on my stock cobra engine. Bought a used mark8 longblock amd it overheated on wife causing a blown headgasket. Needs to be forged. Looking for something that can handle about 600rwhp. Car...

Is this a normal 97 pcm or is it chipped?

. .

Long story short i unplugged my battery then plugged it back in to raise window forgot to unplug my battery again. I unplugged my pcm to install a 2step to splice some wires. Went to connect battery nd saw it was connected. Now my fuel pump wont turn on car cranks but no start. Fuses all good...

I have complete set of 4 off my 97 cobra. Had 81k miles when removed. Both intake and exhaust cams. Asking 225 shipped. 408-757-9525

Im adding a 98 Mark 8 longblock to my 97 cobra, Do i need to add my stock cobra windage tray and pickup or can i just swap over my cobra oil pan and call it a done deal. Mods on cobra are vortech v2 at 10psi with power pipe, 2cat xpipe and cat back. Any help will be appreciated.

So i have my 97 cobra long block that was removed due to a rod knock. I removed all acc. Intake,manifolds,oil pickup,windage tray,oil pan, 4 main studs for windage tray, valve covers. Everything else still intact. Was wondering whats a good price to sell it for. A couple pictures of whats left...

Im putting a 98 long block on my 97 cobra. My question is i want to add my stock windage tray to mark 8 long block do i just remove main cap bolts and re install my cobra ones or?

Hello, i have developed a rod knock on my vortech 97 cobra. Need to get it back on the road asap. I will be getting a 97/98 mark 8 engine. The question it what else do i need to swap over from cobra to mark engine. I know i need a 6 bolt flywheel for a 10.5" clutch. Cobra intake with fuel rails...

Delete Delete