Aeromotive 18680 Eliminator stealth drop in pump for 03/04 cobra. Comes with -8orb/-8an adapters installed. I make over 900whp through a th400 on e70 with this pump.
$650
----------------------------
03 cobra fuel tank
$200
----------------------------
Vortech 12v/18v boost a pump...
New to this area and was called out for a race the first trip out to a Mexican street car show...... I typically don't roll race, but he refused to dig race after the call out so we settled on 30mph and he has the honk. Don't know anything about the car other than its some 600whp deal.
Still...
Heavily leaning towards ARH, but I don't want to pass over Kooks if there is something that makes them better. Looking to order tomorrow and wanted to get some opinions. Kooks says I cannot clear the stock rag joint, ARH believes I can with theirs, and they claimed their primaries are longer.
I have a steggy ported eaton/elbow/TB with 5000 miles on it - $600
Kenne Bell BAP - $200
60lb Deka injectors (5000 miles) - $225
Located in Loveland, CO
I guess I'm getting to the point with my car that I have enough stuff done to warrant a build thread.... I started with an '03 Cobra that I bought back in May. Since I have built an engine for it as well as current mods coming.
Engine is a teksid block, stock bore.
04 cobra crank
oliver...
I upgraded to a whipple 2.9 and A1000 system so my current system is going up for grabs.
Steggy stage 4 port with matched elbow and throttle body. 60lb Deka Injectors, KB BAP, JLT intake w/ Diablo MAFia. I run this setup with a 2.93/4lb, but I'm keeping the 4lb lower. I also have a 2.76...
Finally making some leeway on getting the car back together.
Took me awhile to get everything together and there wasn't a whole lot to post about in the meanwhile.... but I'm starting to put engine back in the car now.
Cleaning up the greasy engine bay
Test fitting...
Before I put my final order in to finish up the car before the engine is out of the machine shop I thought I'd check here and see if I could score any deals with fellow members. I need the following parts:
26spline input
upgraded TOB sleeve
Quadrant/firewall adjuster
IRS diff brace
pro 5.0 or...
collecting parts to upgrade my cobra and I have an extra 2.76 pulley with the hub as well as stock injectors left over.
I'd like $100 shipped in the USA for the pulley and hub, and $150obo shipped in the usa for the stock terminator injectors.
Other parts I still need that I would be...
Currently upgrading my Terminator and would like to sell my stock parts. Unported eaton M112, TB, plenum, 39lb injectors. I'd like to get $550, OBO. Thanks
All stock parts in title pulled from my 2003 cobra as they are getting swapped out. I honestly have no idea what these parts are really worth as I haven't seen a lot of them for sale so I'd like to just say make me a reasonable offer and we'll make a deal. I have no use for this stuff anymore...
New terminator owner
I've been lurking on this site for the past couple of weeks while determining what I needed to look for in a car. I finally found one that fit what I was looking for (except a little higher mileage than I wanted) in Washington. Had a friend go look at it and test...