Search results

Looking to buy a low mileage (under 35k) Evo IX in the PA or tri-state area. Very serious buyer. Feel free to send me a PM with any info. Thank you! -Justin

My brother recently picked up a really nice 95 gt with a ford racing 306/ full bolt-ons. Puts 340 to the ground and sounds mean. Anyway, ever since he got the car, 3rd gear has been giving us an issue. I would guess that 1 in every 20 or 30 shifts into 3rd gear would cause the car to act as if...

Here's a question for all you troubleshooters: Took the car out for a spin today. Everything seemed fine until the car began stalling out every time I hit the brakes hard directly after boost. For example, if I did a little pull and immediately hit the brakes for an upcoming red light, the...

I recently burned out a fog light bulb and want to replace it. I bought the car with an aftermarket HID kit from Xentec. I pulled out the bulb and on the attached wires is a label reading "H10/9245-BL-010111". I searched online for a replacement and literally found nothing. And it appears...

Hi, I had a fog light bulb go out on the car and was wondering what the simplest way of replacing it is? It looks pretty cramped from what I can tell and I don't have access to a lift. Thanks!

For you problem solvers out there, I have one for you. I took the car for a spin today and it was running great. I'm loving the ported blower and 4# lower. Anyway, I stopped to pick up some things from the store, and when I tried to start it up again, it turned over, ran for 2 seconds, and...

Sorry for the useless post, but can someone direct me to the installation instructions for the 170 * thermostat? I know it's on here somewhere but I just can't seem to find it again. Much appreciated!

Hey guys, Quick question regarding heat soak and pulling timing... I just got back from the dyno and the car put down 501/485 at ~ 16psi. It was a 2+ hour trip there, the car did a few pulls on the rollers and the trip home was 2+ hours. It was around 90 degrees outside the entire time...

I'm having a 4 lb lower put on the car and plan on getting it dyno tuned in a few weeks. As long as the car stays out of boost, I should be able to drive safely to the dyno shop, correct? Thanks in advance guys.

So I recently had my car on the dyno with the mods in my sig and it put down some disappointing numbers. Even with a Posi Race port, it made just 482/446.....max boost was only 12.5 - 12.8 psi if I can remember correctly. I'll be putting on a 4# lower next month, but in the meantime, I've been...

Hey, I read through some of the belt sizing posts and wanted to see if some of you guys with experience can help me pick the right size. My current belt is a 75.6'' Dayco, which I'm assuming won't work for my future setup. The car currently has a 2.8 upper, an auxiliary idler, and 3-90mm...

I recently had my posi ported cobra dyno tuned and didn't hit the numbers I expected. She put down 482/447 at just under 13 psi. I'm thinking that maybe my catless headers/h-pipe is keeping the boost on the low side. The tuner recommended a lower pulley to help the blower spin a little bit more...

Hey guys, Finally got my ported 03 cobra tuned yesterday. Before the tune, I was running an email base map for the mods (which include a BAP). I noticed that when shifting at WOT, there would be a split second hesitation and boost drop for a split second, then the car would build power and...

Anyone have recommendations for a good tuner in the Eastern half of PA?

I'd like to preface this by saying that this is the most frustrating car-related thing I've ever dealt with and if anyone could lend me some of their knowledge I would be more than appreciative. It all started this February. While in 3rd gear under boost (about 4k rpm), I heard and felt...

I've searched but couldn't find anything. Does anyone have info on installing the BAP without a wiring upgrade? I ordered a used one and it pretty much came with nothing but a few wires coming out of the box. No manual controller either. Any help would be greatly appreciated!

Hey guys, My cobra has been in the shop for a little while and nobody can figure out what the problem is. The eaton no longer whines and the car feels like it's not getting any boost at all. The motor and supercharger have been checked and both are fine. My next thought was that it could be...

Hi, I'm going the ported route and looking to buy all the essentials (quickly, too). Let me know if you're selling! Looking for: 1) Posi ported eaton 2) Injectors (Siemens Deka 63lb or others that are no-hassle) 3) Fuel pump 4) Mafia 5) SCT X3 Tuner Thanks a lot!

Here is what happened: I was running in third gear at ~5000 rpm when there was a sudden grinding noise up front. The eaton immediately lost its trademark whine and the car lost some serious power. The motor seems fine as I was able to drive home and around the block a few times no problem...

Took the car out for a nice long drive today. ~5,000rpm in third gear (under boost) I heard a very loud, sudden, noise from the motor. At first I thought I threw a rod or something else catastrophic, but I was able to drive the car home. There's no knocking sound or anything like that, but the...

Also posted this in the exhaust section, but here it goes: So for the past few weeks, I've been hearing this ticking noise from my car when I'm driving close to a median or other sound reflective surface. It's not noticeable when driving in an open area. Anyway, the motor itself sounds...

Hi guys, So for the past few weeks, I've been hearing this ticking noise from my car when I'm driving close to a median or other sound reflective surface. It's not noticeable when driving in an open area. Anyway, the motor itself sounds perfectly normal, so I thought it might be something...

Hi, I wanted to see if anyone can help me narrow down a noise I've been hearing in the cobra. The best way to describe the noise would be like a paper business card smacking back and forth over something. I only notice it when I'm driving close to a barrier or some other sound-reflective...

Wanted to share an experience I had lately... I was cruising around Philadelphia with a few friends at 4am (I know) trying to get some of those famous cheese steaks. Anyway, my gps suddenly turned off, causing us to get lost in a pretty sketchy part of town. As I roll up to a stop sign, I notice...

For those of you that have installed a SpeedCal on your 03/04 cobra, which set of directions did you find to be most accurate? Also, do you have any advice that might be useful for me when I install it? Thanks!