I have been looking to get new O2 sensors for the Cobra and I can't seem to find the DY1039 (Green ones) have they been discontinued or what?
Tried to find a replacement but so many Sensors pop up, don't know which to get as I am sure some fail faster than the others, would appreciate some...
This might be the reason, I don't remember going through them, I found these two switches on advantage,
fuel rail pressure failure management select
&
fuel supply failure management select
Traction switch is off
MAF curve is smooth I only fine tuned the STFT's and added a bit of for the open loop.
REV LIMIT ON =6,600
REV LIMIT NEUTRAL ON = 6,600
any other limiter you think I may be missing ?
Unfortunately I couldn't find Spark/Fuel source and I am using FBMM0C6 as a...
spark on the datalog looks completely fine and reaches the targeted Borderline spark ( 13*) but the limiter feels like spark is cutting out since the engine just cutsout and bogs down.
I am building this 2001 Lightning with a GT500 engine swap and a TR6060, Finished the mechanical work and it drives good, shifts good no issues there. Got done with Start up, idle and cruise tuning made sure stft's are on point and when I got up to 4k for the final cruise stft fine tuning i...
Wanted to know who made it and what type of intake did you go with ? If possible to post a pic of the engine baythat may help.
Recently we deleted the SC and decided to go with Sullivan intake manifold which was sent to us missing fow parts that we had to machine out like Injector spacers...
Were facing an issue on my friends Hellion twin turbo Cobra with compound boost,
Car has nothing but a complete Hellion twin turbo kit and a smaller upper pulley.
Issue is that it goes all the way up to 25 psi which is very risky on these engines, I tried almost all vacuum diagrams I...
Just finished swapping in a 2004 cobra engine/trans on a 2004 v6 body.. had a doner car..
Swapped dash harness, cluster, engine harness and PCM.
Car started after deleting the PATS on sct but now when i crank it up the RPM idles way too high .. 2500 RPM and raises slowly to 2800 RPM.
I...
Has anyone done this swap ?
I have a Cobra in for a fuel system swap and was wondering if anyone did the GT500 fuel pump swap on the cobras or not. I can't seem to find anything online except for Ford gt fuel pumps.
Thanks.
I have Ford GT fuel pumps ready, however everyone stopped making the ready harness for a dual module.
So what are my options now ?
I tried searching for a do it yourself harness post but they werent as clear and helpful ...
Thanks.
Finaly received the hellions with 62 CEA billet :banana:
Time to install those babes and I want to make sure its done right, Currently the car has a 2.76 upper, LT, Throttle body and Plenum.
The LT will have to go off as for the rest it should be fine.
I'd also like to know what else...
we recently installed a TR6060 on a '12 Mustang GT and the only problem I am facing is the Wiring, Reverse light, speedo and the Reverse solenoid lock.
Having the Reverse solenoid lock isn't a biggy but I need to work the others...
I appreciate any help or suggestions.. I will post...
I am having an issue tuning one of my friends Mustang GT, His car has
Built 4.6L to 5.0L 9.8:1 CR 3v engine
Compcams STG.3 SPR Camshafts
Ported Heads
Procharger D1SC setup with deleted stock BOV and a Tial 44mm bov.
MaFia Diablo maf extender
Long tubes,
The rest of the mods are...