Recent content by TTUhouston

I take it staying with stock stall then? This 3c feels crazy when daily driving lol Sent from my SM-G781U using Tapatalk

You're gonna mate transmission to engine then drop in together? We just did stall so let me know if you have any questions on transmission install. Sent from my SM-G781U using Tapatalk

Where you goin racing when you get it back together? Let me know, I will gladly lose to that new monster. Maybe I can 60' ya now!!

Finally got the stall everyone said I needed and it helped a lot. I have the 3.33 pulley with wastegate at 10 psi now, 3C stall and E85. Stock headers, intake manifold. I am 1816 on timesheet. It is starting to run what I expected finally!

My 2020 was interesting. Had my 2nd son on July 4th. Car ran more consistent high 10s after installing opg/cs, offroad h pipe, ati crank pulley, 3.33" pulley on paxton and wastegate. I also finally got a way to log boost and may be time to play with wastegate springs... Hoping in 2021 to...

108 in the 1/8 is definitely moving. Nice run Sent from my SM-G930P using Tapatalk

Nice run! Get some low DA and might be close? Sent from my SM-G930P using Tapatalk

What slot is your idler pulley in for those who are running this setup with a gateshd 100" belt? Attached is a pic of where mine is and a little dust on the back. Here is my 2nd gear boost curve too. I have been reading all the old posts on this subject from 2014 and 2015, hard to tell what...

congrats! 9s is an achievement. Glad to see some more stock gen1s in the high 130s for mph in the 1/4! What psi is this pulley? 9?

Actually it was only 2nd best pass in car yet. Best was first post in this chain, 10.75 with a better launch. Otherwise those two runs look pretty identical. Sent from my SM-G930P using Tapatalk

stang910 you may be right on the stall. I do daily this car (2-3 days a week) and not sure the stall is for me. Have son #2 on the way so budget is tight (thus wastegate instead of stall).

The mph should be up around 135 when i get this setup dialed in. I could always turn the boost up on the wastegate to get more mph too but im gonna get it working good at 10 psig. note- this was first pass on new setup... yes mph and ET are slow.

I got the wastegate to solve that problem. Sent from my SM-G930P using Tapatalk

Timeslip Sent from my SM-G930P using Tapatalk

Not bad, tune still needs work only made 1 run. 1st gear didnt switch til almost 8100rpm, need to fix that asap. Also only 20deg of timing. Hoping for 10.50s when that is worked out.