I'm selling a 2015-2016 Mustang GT350R Steering Wheel Kit. It was installed and used for about 6 months. Comes with everything that came in the box from Ford Racing. Still New condition.
$290 shipped.
I bought these from corral members and I ended up not using them. They are still in the shipping box they came in.
PAS Xtreme Mass Air Sensor with 4" Housing - $190
60lb/h Siemens Deka Injectors EV1 - $250
OBO
I am selling my Flowmaster Scavenger X pipe. I had it installed on the car for about a month and a half. It sounds good especially with the Flowmaster Outlaws. I decided to go with a custom H pipe. When I had the Flowmaster X pipe installed, about a half of an inch or less was cut off the back...
I am going to get CompCams new CR series camshafts after I complete my exhaust. On their SEMA video they are claiming 50-60hp from these cams. I am looking for a shop to install them and dyno-tune it at the same location. I did some searching and I haven't seen much info on them. I guess I'll be...
I have a Brand New in the box Aeromotive 340 fuel pump for sale. Part # 11140.
Aeromotive 11140 Aeromotive 340 Stealth In-Tank Fuel Pumps
$150 shipped
[/URL][/IMG]
[/URL][/IMG]
I am selling my R 302 block. I was planning on putting together a 363ci setup for boost. I have collected all the parts for the shortblock, but since it's not together yet I've decided to sell it. The rotating assembly is for sale in my other ad.
Specs on the block
Bore: 4.105"
stroker...
Change of plans sale!!
Along with my R 302 block I have for sale in another ad, I am selling the rotating assembly which consist of: eagle crank, eagle rods, probe srs pistons, perfect circle fire power ring set, clevite main and rod bearings.
The crank and rods are used (was used in the...
I searched and didn't find this anywhere so I'm posting this up if everyone haven't seen this. I think this is a great deal for a fully forged low compression coyote!
Ford Racing Performance Parts
--------
Ford Racing's 5.0L Mustang "Aluminator" crate engine is a modern 5.0L 32-valve DOHC...
I'm looking for a good shop where I can get my heads completely worked over. Within the South GA or North FL area. I'm looking for a local shop but if I have to ship them I will.
I am selling my Mallory Ignition System. I'm going a different route with the car. I will also be parting my 398w stroker.
Mallory Hyfire Ignition 6853M - Mallory Ignition 6853M - Mallory HyFire VI-AL Digital CD Ignitions - Overview - SummitRacing.com
Mallory Promaster Coil 29625 - Mallory...
I have 2 Magnaflow bullet mufflers (same as the JDM silverbullets). They was welded in place of the stock mufflers. I'm going with a completely different midpipe and catback. asking $100 + shipping
I will have the exhaust removed this afternoon.