Recent content by poneypower

stock tranny. mods in sig. Car has the stock clutch on it and I believe it has seen better days. I'm guessing if I go with Mcleod, Centerforce Ram or Spec I would just need to pick one I like, they are probably all quality pieces.

I need to get an estimated value for my car outside of Edmunds and KBB. Car has ~60k on it, I'm the second owner. Details on mods in my sig are: Mach 1 SRA w/ welded tubes FRPP 4.30s carbon clutches for diff Stock Mach 1 diff and axles CHE double adjustable uppers w/ spherical bushings...

Is the dash wiring harness out of a Mach 1 compatible with an 01 cobra? I'm talking the whole thing.

So I sprayed the car last night for the first time to test everything out. System is the Nitrous Express drive by wire kit (wet). I run a FP safety switch as well. I learned the little computer, armed the system and achieved WOT. Car felt amazing, definitely felt the hit from the 100 shot...

Annual Mustang Rally of the Finger Lakes car show. Proceeds benefit Habitat for Humanity. Mustang Rally door prizes, raffles, food and music. In conjunction with the Phelps Sauerkraut Festival which has numerous food vendors, rides for kids, world famous Sauerkraut Cake, cabbage bowling...

take a look at this. is this space between the spacer and the rotor right? i don't remember it being like that on my IRS.

Never had a problem with the rear brakes with the IRS. After I installed the SRA, the passenger side wheel gets extremely hot after driving for more than 10 miles. To the point that it stings a little touching it. The drivers side wheel is fine. I have lubed up the sliders on the...

I swapped in a live axle last year and it came with 4.10 gears. I had a show coming up and needed to have everything done, so I just went ahead with using the old 4.10s. Well they were a little worn and they whine like crazy. When I had them installed I did the master install kit with all...

For sale: 03/04 Mach 1 dash wiring harness, complete. looking for $125 shipped. all boxed and ready to go.

Looking for the harnesses for the radio in an 2001 or 2003 Cobra. Not sure if the 99 is the same or not, if it is that will work too.

If i sit in the car, with it in gear or in neutral , and rock back and forth in my seat I hear a clunking coming from the rear end. I recently dropped in a solid axle. any ideas? I went over all the control arm bolts and such, but I am going to do it again tonight or tomorrow just to be sure...

If you are, are you running a window switch of any kind? I finally have the car all ready to get to the dyno and am planning on hitting the track in the next couple weeks and wanted to check what others were running.

These fit fine on my IRS but they will not sit flush on the solid. are they not interchangeable between the different rear end types?

Anyone know the size of these bolts? I seem to have sent mine with my IRS when I sold it. I got my live axle in tonight and when I went to mount the calipers I noticed that the bolts were gone. I was gonna pick some up tomorrow but I don't have a clue as to the size. These are for the stock...

I have a mach 1 solid that is going in my 01 cobra. I bought the axle bare, it was not a swap so I had to gather a few parts. I was hoping to reuse my stock drive shaft and ran into one issue when they were setting the 4.10s up. They ordered a new pinion flange but it was the larger 3x3 bolt...